Wiring Harness 14-Pin - Universal Wiring Harness (assembly required)

Part ID:

21220-U2

Allows tilt function operation from joy stick controls. Universal wiring harness. Contacts are crimped on wire but not installed in connector.

NOTE: Requires connector contacts be installed in a switchable +12 V pin location & ground pin location. Mapping of skid-steer connector pins required.

NOTE: Danuser strives for accurate up-to-date information. Skid-steer manufacturers are continually changing specs. It is the installer's responsibility to make sure this wiring harness is suitable for the skid-steer. Danuser assumes no liability for product selection and/or installation.

How To Buy

Warning

This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/product.