Comp Coil Unit

PART ID: 50059

The Comp Coil is a fully adjustable “Compression Spring” recoil reducing device offering a 5/16” maximum stroke. For large bore guns, no compression cylinder support is needed. A hole 1” in diameter by 1-5/8” deep is needed for the compressing cylinder, so in most cases the Comp Coil can be mounted on semi-auto firearms. The Comp Coil, without a mounted recoil pad, from outside of base plate to the outside of back plate is 1” in length. The base and back plates are primarily the same as the Counter Coil’s and the installation fixture and drills work for both units.

  P65 Warning WARNING
This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to


QuantityPrice / ea

Comp Coil Unit Weight:    Little over 1/2 lb. (does not include pad) 


  • Comp Coil Unit
  • Two Foam Bushings
  • Mounting Screws
  • Adjustment Wrench
  • Owner's Manual

A glue on or screw on pad will need to be purchased separately. 

50020 Allen Wrench (back casting)
50013 Set Screw
50022 Foam Bushing
50024 Brown Butt Pad (glue on)
50025 Black Butt Pad (glue on)
50032 Drill Fixture
50033 Drill Bushing
50034 1-1/16" Drill with 1/2" Shank
50051 Recoil Pad Adjustment Kit
50052 1/2" KICK-EEZ Recoil Pad
50052-1 1-1/8" KICK-EEZ Recoil Pad
50052-2 3/4" KICK-EEZ Recoil Pad - Trap Pad
50030 Back Plate Assembly
50035 9/16" Drill with 1/2" Shank
50036 1/8" Drill
50037 1-1/4" Wood Screws (set of two)
50019 1" #10 Wood Screws (set of two)