Python Wire Winder

PART ID: 170610

The Python Wire Winder takes the bite out of rolling up fence wire.  With features like tie wire grooves, ten wire starter slots, and retention pin storage, the Python is sure to put the squeeze on your next wire wrapping project.  To wind up a single strand or multiple strands, simply attach the Python to a hydraulic auger drive with 2” hex, place the two tie wires in the grooves, then place the fence wire strand(s) in the slot(s), and turn on the auger drive to start wrapping.  Tilting the drive unit toward and away from the direction of the wire will allow for even spooling. Once the wire is wrapped up, wrap the tie wires, pull the pin, separate the two halves, pull the roll of wire off, and reassemble the Python to start on the next section.  


  • Can roll up to ¾ mile of barbed wire (12.5 gauge) or six miles of smooth wire (14 gauge)
  • 2” Hex connection mounts to existing hydraulic auger drive
  • 2 Tie wire locations
  • 10 slot locations to start wire
  • Toolless operation
  • Convenient retention pin storage locations
  • Roll multiple wires at one time
Note: Note for use on PTO diggers.
How to Buy Watch Videos
  P65 Warning WARNING
This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
Overall Width (A) 22"
Overall Height: (B) 34.18"
Weight 90 lbs.
Wire Capacity

Up to 3/4 mile barbed (12.5 gauge)

Up to 6 miles smooth (14 gauge)

Output Spindle Connection 2" Hex

10923 Adapter - 2-9/16" Round to 2" Hex